1989 Evinrude 120 Looper Thermostat Swap

DeereDiesel

Recruit
Thread starter
Joined
May 24, 2016
Messages
3
I have been doing some searching and have come up with mixed instructions each time so I thought I would start a new thread. The water control valve on my engine is leaking. I have read you can swap parts with an 89 or 90 70 hp evinrude. Different posts suggest different parts. Does anyone know exactly what parts I will need?

Thanks for the help!
 

DeereDiesel

Recruit
Thread starter
Joined
May 24, 2016
Messages
3
I know you need the thermostat covers and the spring. Is that all would need? Or do you have to replace thermostat, vernatherm, grommets, seals, cup, everything? I'm new here and was able to find a wealth of information without posting. This one has me confused and I didn't want to buy more than what I needed. Thank you.
 

DeereDiesel

Recruit
Thread starter
Joined
May 24, 2016
Messages
3
I looked back to 2011 and still have mixed results on what parts. I did however find awesome info on what to do with the hoses afterwards. One thread will say covers, gaskets, spring. the next lists You will need the following:
(2) 0333858 springs
(2) 0333967 covers
(2) 0329830gaskets
(2) 0394409 t-stat assy or
(2) 0394411 veratherms 140?

I'm not trying to waste your time here I just don't want to get the wrong or unnecessary parts and overheat my engine. looking at the parts breakdowns there are two springs as well. If I bought number 37 on that breakdown, would it also include 39 and 36 since it looks like they belong inside of it? I'm new to working on outboards and don't want to mess this up. I've rebuilt the carbs and done some minor maintenance and aside from the water leak it seems to run great. It idles nice, sounds good through the rpm range, pee stream is healthy. I appreciate the help, thank you.

convert
 
Top