1988 Johnson 40 hp electrical

hydraulicguy

Recruit
Thread starter
Joined
Jun 13, 2014
Messages
2
I have a 1988 Johnson 40 hp with tilt and trim . My nephew came over and asked if my boat ran and of course I started it but the starter hung up while motor was running causing Harness to burn up badly .. But the motor was still running when the battery was disconnected .. My question is since I replaced the harness why am I not getting any fire to my cylinders ??? Any help is appreciated thanks .
 

Bondo

Moderator
Staff member
Joined
Apr 17, 2002
Messages
71,545
My question is since I replaced the harness why am I not getting any fire to my cylinders ???

Ayuh,.... Welcome Aboard,..... My guess is, ya wired something wrong,.....

I'll move this to the johnson outboard forum for ya,.....
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Kill switch checked?

find the five pin amphenol connector. Dis connect it. Jump the four wires that are NOT blk/yel. This leaves the blk/yel open. Check spark and report findings.
 

hydraulicguy

Recruit
Thread starter
Joined
Jun 13, 2014
Messages
2
Some people are telling me to pull the flywheel and check the stator ??? If it was running when the battery was disconnected how could that be burned up ?? Thanks
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Lets just start from the beggining and do what I mentioned in post #3. It only take a half an hour
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
You can not check the stator by pulling the flywheel. Yes, it is under the flywheel but that is not how you diagnose it, we may or may not get to that point.
 
Top