1988 DT115 oil injection removal.

[ttho3177]

First off LET ME SAY THANKS IN ADVANCE FOR THE HELP. I am removing the oil injection where i can run premix gas. I am doing this due to a prior failure which caused the top cylinder to sling the rod. If anyone has knowledge on this and you don't mind explaining what steps did you take as far as the pump? Did you leave it or remove it and what wires need to be connected together or left disconnected?
Any help will be greatly appreciated.?

 

[eddie haskell]

You can just plug each port, or anywhere after the pump if you only want to do it once.
You will still have the pump drive spinning, however. I know of nothing that will bypass this.
If you just service your oil injection system regularly, cleaning or changing the filter, etc, its the best way for this motor to operate, as it mixes according to speed.
Your wires don't matter as your system is not functioning anymore, its a closed loop that sets off the alarm if it opens (flow switch)