1988 70hp Evinrude Water Pump Replacement

msimpson99

Recruit
Thread starter
Joined
Jun 6, 2016
Messages
3
Symptoms - Wasn't peeing while running on hose unless I squeezed muffs or increased throttle. Buzzer sounded so I shut it down.
Paid mechanic to replace water pump impeller because I didn't have time. First 3 trips to the lake everything worked fine. On the fourth trip I got about a mile from the landing and experienced the same symptoms as prior to the impeller replacement. That was last year and I just parked the boat due to lack of time to work on it. Just recently ordered a replacement pump kit and discovered that the semicircular opening in the wear plate is smaller than the opening on the old one. Contacted supplier who verified that this is the correct pump and that there had been a design change.

Wear Plates.jpg

Info on the internet is confusing but looks like I may need to make some other changes (thermostat spring, location of telltale hose) to use the newer pump. Can anyone tell me what is required?

For what it's worth, the "old" impeller did not appear damaged and both old and new impellers are 6 blade. Looks like the housing o-ring was pinched and the impeller cup was slightly out of place when reassembled last time.

Thanks in advance.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Water pump kit #0432955 would have had everything you need to make those changes. Here is the bulletin it comes up as a download for some reason. If the telltale comes off of the top of the block the relocation has been done. You also need to take the end of the telltale off and let the water run out of the hose.
 

Attachments

  • evinrude 70 hp service bulletin.pdf
    550.3 KB · Views: 7

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Like flying Scott said there should be a detailed instruction sheet that came with kit. Follow it to a tee.
 

msimpson99

Recruit
Thread starter
Joined
Jun 6, 2016
Messages
3
Thanks guys. My kit has all of the water pump parts but no modification parts. Shouldn't be a problem finding parts to do the telltale mod but I'll have to check my thermostat to see if the spring needs changed. Thermostat was replaced several years ago when the engine was rebuilt but since they didn't do any of the mods I doubt they used the newer spring.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
All you need is the updated spring for the thermostat and if you need to relocate the tell-tale tale. You will need a brass plug to plug the lower hole a new elbow for the top. You will also need a new grommet for where the tell-tale exits the lower cowling.
 
Top