1986 Thundercraft Distributor??

Chiboka

Cadet
Thread starter
Joined
May 15, 2007
Messages
24
Re: 1986 Thundercraft Distributor??

Would the sheared off split pin ends be in the oil pan? Could they get back up into the motor or is their a screen on the oil pump intake? The split pin pieces that broke off to cause the gear to come off are small. Should I be concerned about it?

Thanks
 

Fishermark

Vice Admiral
Joined
Oct 19, 2003
Messages
5,627
Re: 1986 Thundercraft Distributor??

I would change the oil at the very least and see if they come out with the oil. There is a screen on the pump and they couln't get sucked into the pump... but they could interfere with the rotating mass and cause some problems if they stay in the bottom. I don't know that I would pull the engine just to get them out, but maybe a big magnet at the bottom of the pan to keep them there if they don't get flushed out with the oil.
 

Chiboka

Cadet
Thread starter
Joined
May 15, 2007
Messages
24
Re: 1986 Thundercraft Distributor??

Thanks for all the great info. I have run the boat over the past weekend & all is well. I will take your advice and use a magnet to draw the pieces to the drain plug. I'll use a screen to see if they come out. More than half of the split pin was left in the distributor shaft. Ends were sheared off from wear and tar I guess over the years.

Thanks again.
 
Top