Dale Tanner
Cadet
- Joined
- Aug 24, 2012
- Messages
- 7
The tilt/trim system had been working fine until the last outing when the boat was loaded onto its trailer with the stern drive in the down position and then the boat trailer was allowed to roll backwards with the outdrive keel still on the concrete ramp......... .the motor/ worm gear still operates but the ACME screw does not move, even when tapped on the end with a hefty hammer. The manual that I have does not show any pushrod or linkage and I cannot see anything when the outdrive is lifted manually. I would certainly appreciate some input....Thanks
