1986 70 horsepower vro johnson water pump issues

sgreen156

Recruit
Thread starter
Joined
Jul 1, 2016
Messages
4
alright guys, this is m first boat, so i will try my best. there was no water being pumped into the block, so i got a water pump rebuild kit. when i put it together there was an oring that from the other videos i watched went on the top of the driveshaft but its too big for it to fit there. Does it go between the impeller and the plate, or the impeller and the cup housing. while the oring was on top of the water pump, if i poured water into the water outlet tube, it would leak out of the top of the water pump around the driveshaft. is that supposed to happen. also, i had moved the oring to in between the impeller and the pump housing, and once i had the bolts tightened down, i couldnt turn the driveshaft with my hand, is that good or bad? I appreciate any help you guys can give me. thanks.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Put up a pic of the o ring there should only be 2. One goes around the housing is kind of an odd shape and one goes at the top of the driveshaft.
 

sgreen156

Recruit
Thread starter
Joined
Jul 1, 2016
Messages
4
i cant remember. the oring that came in the kit fell down underneath my deck but i took the old one and matched it, and it fits around the bottom of the driveshaft but not the top by the splines. is there supposed to be water coming out of the top of pump around the driveshaft?
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
A little maybe. Sometimes with different manufacturers the oring goes between the cup and the housing, or between the base plate and the imprllar, or between impellar and cup just to name a few.

Oem would only have one for the top by the splines.
 

sgreen156

Recruit
Thread starter
Joined
Jul 1, 2016
Messages
4
so when i got the boat and took the lower off to replace the water pump, there was an oring up at the top by the splines, and then one down at the bottom, but the kit only came with one that was too big to go around the driveshaft up top. should i take the one that i put between the impeller and the cup out?
 

sgreen156

Recruit
Thread starter
Joined
Jul 1, 2016
Messages
4
so i took the water pump back apart and made sure everything is right! put it back on the boat, and i just turned the motor over, didnt actually start it and it didnt seem like there was any water coming through the block as i had the thermostat housing off! i have blown air and water through the tell tale and it came out the inlet tube going from the impeller so i dont think i have a blockage of any sort! is there something else that needs to be closed or open? when i ran water through the tell tale and poured it directly into the thermostat housing, it seemed like it all drained out of the front of the lower unit somehow, because i had it submerged! this thing is really starting to **** me off because i cant figure out why its not pumping water and havent been able to find a good way to try and fix it!
 
Top