1986 50hp evinrude (E50TLCDE) shift and throttle linkage help

[Benjamin_14]

Hey guys, I need any advice or help you can give me in trouble shooting this. The throttle linkage on this boat isn't very smooth and it seems loose. I have looked everywhere trying the find the correct replacement parts but all i can find on this specific motor is the shift and throttle linkage for a tiller handle. I plan on getting the original manual to set it up correctly since everything is out of wack already but i just need some pointers on what to do since I cannot find these parts anywhere. Thank y'all!!

 

[racerone]

Your location ?---Where how have you looked for these parts ?-----And if you have the part #s you will be able to find parts via ---E-bay and other places.---

 

[Benjamin_14]

Im located in Louisiana, but I've been through every evinrude/johnson parts dealer website but this is what im seeing, they all have the shift and throttle linkage for tiller electric motors which look completely different.. i wish i knew the part numbers and im not exactly sure how to find them as of right now..

 

[Benjamin_14]

This is all i can find on any website

 

[racerone]

So is your motor a tiller motor ?-----Pictures show a remote motor.----------Been converted to remote ?------You totally looking this up wrong.----go to ----evinrudeparts.ca-----And find the part numbers for this motor !!-----Look on the cylinder / crankcase page.

 

[Benjamin_14]

Did that and decided why not look through the other diagrams they have on that site and low and behold it was on the crankcase and cylinder diagram, hard to see and pick out. Should i put some lube grease on the old moving parts that I'll be putting back on? i do appreciate you my man! You'll probably see me with another dumb question when i go to tune the carbs lol