Shade tree living
Cadet
- Joined
- Oct 8, 2016
- Messages
- 14
I need help verifying if I have correct voltage to tilt motor. New motor testing installed but quad gear removed(not under load). When activating tilt switch for 5-7 seconds the motor speed reduces and voltage drops. Clutch pack, hammer blow, worm gear all clean with new oil. All connections cleaned, sanded and elec grease applied.
Testing with fully charged battery with key off, on, then with tilt switch activated for 5-6 seconds.
Batt 13.06V, 12.35V, 11.14V
Start Sol 13.06V, 12.36V, 10.76V
Start Asst Sol 13.06V, 12.22V, 10.85V
Tilt Sol Input 13.06V, 12.22V, 10.45V
Tilt Sol Out (switch activated) 11.06 to 10.4 drop.
Tilt Sol input from dash switch 9.47 to 9.2.
It seems to me that as the voltage drops the tilt motor slows down.
Is this much voltage drop normal?
Any help/ideas would be greatly appreciated.
Testing with fully charged battery with key off, on, then with tilt switch activated for 5-6 seconds.
Batt 13.06V, 12.35V, 11.14V
Start Sol 13.06V, 12.36V, 10.76V
Start Asst Sol 13.06V, 12.22V, 10.85V
Tilt Sol Input 13.06V, 12.22V, 10.45V
Tilt Sol Out (switch activated) 11.06 to 10.4 drop.
Tilt Sol input from dash switch 9.47 to 9.2.
It seems to me that as the voltage drops the tilt motor slows down.
Is this much voltage drop normal?
Any help/ideas would be greatly appreciated.