1985 Evinrude 150 VRO cuts off after 30 seconds

vballmike

Recruit
Thread starter
Joined
Jun 26, 2018
Messages
5
The engine will start fine and run for 30-40 seconds at idle, then cuts off. Will run for maybe 5-10 seconds at speed. This is what I've had done since the problem started.

A mechanic friend changed all the fuel lines, replaced plugs and wires, fresh fuel and did a rebuild on fuel pump.

Same thing. 40 seconds, then dies. Same thing regardless of where manual choke is set.

When he connected to an external fuel can and raised it above the engine it ran and did not cut off.

Does this pretty much point to the fuel pump?

Thanks for the help!!
 

jdlawson

Cadet
Joined
Jul 9, 2012
Messages
6
That's what it sounds like to me. I'm pretty sure you can get a rebuild kit for it. It alot cheaper that a new vro.
 

vballmike

Recruit
Thread starter
Joined
Jun 26, 2018
Messages
5
It has a primer bulb as well as choke. The pump was rebuilt, but I've heard they have fairly high "no go" rate! I think I need a new pump!
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Have you tried pumping the primer ball while this was happening? Have you looked at the vro pulse line is it in good shape? A 1985 motor would have a primer not a choke.
 

vballmike

Recruit
Thread starter
Joined
Jun 26, 2018
Messages
5
Sorry, should have posted this in op. Model # E150TLCRD . And I was mistaken. It's an 1984. Sorry . . .
 

vballmike

Recruit
Thread starter
Joined
Jun 26, 2018
Messages
5
Ok, yes, has the primer solenoid. When I push the ignition key in, I can hear it click. It still starts and runs for 40 sec, then dies. Tried pushing in the key when it starts to die, still dies. Tried pumping the bulb when running, still dies.

AND, when pumping the bulb to prime it, discovered a gas leak! Seems to be coming from the top gasket, either #46 or 47, referencing the schematic mentioned by oldboat1 above!! Doesn't seem to leak when running!

Woohoo. Thanks again for all your help!!
 

vballmike

Recruit
Thread starter
Joined
Jun 26, 2018
Messages
5
More info . . . did a voltage test on the primer solenoid and got 12 volts when I pushed the key in.
 

Funguz

Cadet
Joined
Jul 5, 2018
Messages
8
Not sure if this is your problem, but I have a 2000 Johnson 115 V4, and mine did the exact same thing. Checked the primer sel, VRO, spark, compression …drained my tank, cleaned the fuel, all were good. Mine would die after about a min then I’d notice fuel coming out of the two bottom carbs then she’d be impossible to start until the fuel aired out, I would up rebuilding my 4 carbs/float bowls over July 4th …she fires right up now and doesn’t die anymore.

But now my idle is crazy high, like 2100!!!! Got it back to 1600 with adjustments to the air/fuel screw, and idle adjustments on top near the timing. Still high. Throttle rod/cable not stuck or anything. I’m guessing I’ll need my local guy to do a final adjumsent to timing, air/fuel, and syn the carbs. I’ll let you know, taking it hopefully in today.
 
Top