1984 Johnson J70TLCRD 70hp

Too Dogs

Cadet
Thread starter
Joined
Aug 16, 2013
Messages
20
Hard start after initial start but if given a half second squirt of starting fluid, it fires right up. It runs fine after starting. Suspect carb problem?
Bulb is new and hard but sometimes has to be pumped soon after running. Should I have a check valve in the line? Boat is 80's vintage Blue Fin with a front mounted, built in, 20 gal tank.
Also, trim/tilt is stuck with pistons extended. Release screw lowers tilt piston only. Pump/motor run both directions. would you suspect dirt in valves? Is there a company that rebulds/repairs other than a boat motor repair shop?
Thank You, Jerry
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Is this motor new to you? How much time between starts? Is the choke/primer working? Is the T/N/T full. Have you checked compression and Spark? The bulb will be soft after starting that is normal
 

Too Dogs

Cadet
Thread starter
Joined
Aug 16, 2013
Messages
20
New to me. TNT is full. Have not checked for intermitant spark, compression was good last fall but willmake checks. Thanks
 

Too Dogs

Cadet
Thread starter
Joined
Aug 16, 2013
Messages
20
Just returned from FL. to MI. I had start problems in FL. and home, it required manual activation of choke to start. I ran it to warm up, then shut it off for a half hour and it started normally, several times.

Cyl PSI; 120,120 and 125.

I hear choke "click" when pushing in key but I cannot see the "butterfly" move. Should I? Should butterfly be closed while running? Motor runs normally.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
You may find that the 84 models had an electric primer valve.----Thus no " choke flappers " on the carburetors !
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
That's not a choke butterfly, that's the throttle. As r acerone states you have a primer valve operated by solenoid.
 

Too Dogs

Cadet
Thread starter
Joined
Aug 16, 2013
Messages
20
I checked the choke, per Flyingscott suggestion and while I hear it click, I disassembled and cleaned it. Ohm measurement before and after is 10.6. Manual states 5.5 +/-- 1.5 ohms. Should I assume it is bad? Thanks
 
Top