1983 Johnson 70 hp o/b high idle!!

Joshuadbivens

Recruit
Thread starter
Joined
Jun 3, 2016
Messages
1
I recently bought a bayliner capri with a 70 hp Johnson and got new controls for it connected all my wires and linkage and started her up ran what seemed to be fine for about half a second and then the motor just took off at max rpms!!! Turned the key off and motor was still running pulled the kill switch and again motor still running and pulled the plug wires and it shut off I have no idea where to even begin and need all the help I can get all replys are greatly appreciated.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Is the big red plug plugged in are the cables adjusted correctly you need to adjust the throttle cable so it pulls the throttle tight to the stop
 

tlewis1

Petty Officer 2nd Class
Joined
Oct 9, 2012
Messages
112
Start with removing the air box cover so you can see into the carbs and ensure that the butterfly's are fully closed when the throttle handle is in neutral. From there you can set both the shift and throttle cable adjustments as needed.
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
First thing to do is ohm out the key switch so you will be able to shut it off. Make sure you have continuity between blk/yel and ground when switch is in off position
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Also make sure your powers pack is grounded with a star washer
 
Top