1983 Evinrude 115V low compression starting issues?

mppnaj12

Recruit
Thread starter
Joined
Jul 12, 2012
Messages
1
Hey Folks,
I am the original owner of an Evinrude 2 stroke 115V outboard motor which I bought brand new in 1984 with my Ski Boat. I have less than 800 hours on the motor and have never had to do anything but replace spark plugs. The motor has been fantastic, in 1984 the boat topped out at 42 MPH and last summer it still topped out at 39 MPH. All of the sudden last summer the boat wouldn't start, I went back home replaced the spark plugs, sprayed carburetor cleaner and ran the motor in the driveway just fine. Went back out to the lake the next day boat won't turn over, the boat will start with the water hose in the driveway but won't start at the lake. I don't have any Evinrude dealers around anymore so I took the boat to a Mercury dealer for diagnosis. They pressurized the cylinders at 90 PSI and stated the compression test results were. 1. 73 PSI, 2. 82 PSI, 3. 70 PSI, 4.84 PSI. From this result they stated I had too much loss and would explain my symptoms, they stated find somebody who rebuilds motors, is there something I can check without tearing the motor completely apart?

Thanks

Matt
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
How many times have you installed a new impeller for the cooling system ?---------------Remove cylinder heads and inspect cylinder bores.-----Then you might be able to determine what needs to be done.
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
I would think the original factory compression on your engine would be in the 95-100 lbs range. A useable engine will maintain compression within 10% of the new factory reading and still make good hp. Unfortunately, your readings are all low. While you may get it to run with those numbers, it won't make much hp the way it is. The first thing would be to do a DECARB on the engine. Maybe two times-doesn't hurt to do this multiple times. The numbers won't change much, but they may come up somewhat, making the decarb process worthwhile. Keep in mind that it's easy for an engine to start/run when on the trailer in the back yard. Does not take much to push the exhaust out the prop. When the boat is floating normally in the lake, that's another thing. The engine has to push 20" of water out of the way in order to exhaust out the prop. Takes more compression to start it in the lake. I'd follow racer's suggestion. Pull the heads and see what the pistons, ringsets and cylinder liners look like. Esp look for cylinder liner scuffing and broken top rings. Broken rings will create dents in the top of the piston crown and the face of the head.
 
Top