1983 evenrude 75 hp

medicman985

Cadet
Thread starter
Joined
Feb 12, 2017
Messages
7
bought a 1983 boat with 75 hp evinrude outboard motor. the problem is it revs real high in reverse and doesn't seem to want to drop in reverse gear. runs fine in forward, but wont allow reverse due to high rpms. any help would be great!
 
Last edited:

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
"Revs real high in Reverse", or "Doesn't seem to drop in reverse gear". Which is it?
 

MaPaHa

Petty Officer 1st Class
Joined
Jul 6, 2012
Messages
239
It sounds like the throttle cable and shifting cable are not synchronized. If I'm understanding right, the motor revs up before it engages in reverse. The throttle and shifting cable can be adjusted at the motor where the shifting is complete both ways before the throttle speeds up. With the motor off, get someone to slowly move the throttle back and forth and I'll bet you'll see the throttle moving while the shifting cable is still moving.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Make sure the shift rod going into the lower unit is set correctly.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Post # 1 says forward works fine !-----Check the shift rod height first !
 

medicman985

Cadet
Thread starter
Joined
Feb 12, 2017
Messages
7
ok I adjusted on shift cable at motor,,finally drops in gear like it should,at least on dry land. only have about an 1/2 inch adjustment left on motor end. is there more adjustment in the gear shift box if I need it. or should I just get a new shift cable.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Check the shift rod height first !!------There is no adjustment feature in the control box either.
 

medicman985

Cadet
Thread starter
Joined
Feb 12, 2017
Messages
7
ok, got the linkage adjusted ok .seems to drop in to reverse now from idle. thanks for the help.
now, took it to the lake and the sucker wont start. almost does fire up right after choking it. mind you it had run fine on ear muffs here at the house just prior to that..it is cold natured.,but .im about fed up.so got to the lake and no start,,ran battery dead trying to get it going.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Facts-----The motor must crank at about 300 RPM or so in order for the magneto to produce spark.-----Get battery tested.----Take starter apart for inspection.-----Did you do a compression test on this motor ,----Post the results.
 

medicman985

Cadet
Thread starter
Joined
Feb 12, 2017
Messages
7
battery was weak,,replaced it. also just went out and started it this morning on muffs. start then die.. then found this lever that raised up on side of gear selector lever. and wala. it started up fine with a little raising of that lever. don't know what it does,but soon as it hits,i can raise the lever up and it revs motor up, then move it back down to get idle..go figure..
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
That lever opens the throttle without shifting into gear.---It must be raised for cold starting.-----Do not let the motor rev wildly in neutral.----That is bad for needle bearings !
 
Top