1980 johnson 9.9 outboard won't idle

Goofy31

Recruit
Thread starter
Joined
Sep 5, 2017
Messages
3
I have a 1980 johnson 9.9 that won't idle with the tiller handle but I put a string on the throttle of the carb so I could pull it by hand that's the only way I can get it to run and idle so what do I need to look at

Thanks for looking
 
Last edited:

Goofy31

Recruit
Thread starter
Joined
Sep 5, 2017
Messages
3
What's a good compression for this motor and I forgot to say the only way it will run with the tiller handle is full throttle someone was saying it could have slack in the tiller handle
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
They all have slop in the tiller handle. 90 psi and above is good compression.
 

Goofy31

Recruit
Thread starter
Joined
Sep 5, 2017
Messages
3
Ok I'll try to do the test today if the compression is good I'll do a spark test

Thanks for all the help
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Operating the twist grip should advance the timing at the same time the carb butterfly is opened -- timing is advanced by rotating the timing plate under the flywheel. The carb butterfly is opened by the cam follower and roller assembly on the carb, which is contacted by a cam attached to the rotating timing plate.

Synchronizing movement of the plate with the carb throttle butterfly is the link and sync procedure.

I'm hearing you say you are pulling the carburetor throttle butterfly open with a string. Assuming the timing plate under the flywheel is moving (it sometimes doesn't), you need to sync opening of the carb butterfly with rotation of the timing plate.
 
Top