1980-ish outboard no spark PLEASE HELP

[Coreyg17]

from pictures I found online I have a 1980 9.9 Seaking by chrysler outboard. I replaced the condensors and everything checks out. some of my ohmage readings are a little low but other than that I cleaned points and everything else checks out, yet I still have no spark. my kill switch is bad so i disconnected the brown kill switch wires in the magnito, still no spark. I have done hours of research and tried everything possible. What am I missing? (I can post pictures if need be)

 

[jerryjerry05]

Try connecting the kill leads together?
Some times the points need filed down, sanding might not be enough.

 

[Coreyg17]

Try connecting the kill leads together?
Some times the points need filed down, sanding might not be enough.

Okay I will pick up a points file today. Everything under the flywheel has rust or corrosion. The metal around the coils used to be rusty but I cleaned them off. Do you mean tie the kill switch end together with them connected in the magneto? Or vice versa?

 

[jerryjerry05]

Just the ends of the wires that hooked to the switch.

 

[Coreyg17]

Just the ends of the wires that hooked to the switch.

I tried that, still no spark

 

[jerryjerry05]

Take everything off and clean out the rust.
You might need to replace everything under the flywheel

 

[Coreyg17]

Take everything off and clean out the rust.
You might need to replace everything under the flywheel

Oh man okay, even if everything checks out using impedance on a multimeter? Should I replace everything with a low reading even if it still reads?