Engine rebuilt 2 years ago and sat. Will start but once I let key switch go from "start" to "run" position she dies. If I keep in start position she will continue to run? I did change the handle ( throttle ) and left off the neutral safety switch. White wire is live on left side of switch box when key is in "on" position but nothing on right side until I put key switch in "start" position. Maybe I need new parts for this process. I was hooking and unhooking and ran two batteries in parralel .. maybe I fried something? I did take carbs off and soak in cleaner and put back on.
1. does stator have to function for engine to run in on position?
2. does rectifier have to function for engine to run in on position?
3. does switchbox have to function for engine to run in on position?
4. possible carb issue?
5. Ideas?
Thanks !!
1. does stator have to function for engine to run in on position?
2. does rectifier have to function for engine to run in on position?
3. does switchbox have to function for engine to run in on position?
4. possible carb issue?
5. Ideas?
Thanks !!
Last edited: