1979 johnson 140hp water on plugs HELP!!!

Saltydog99

Recruit
Thread starter
Joined
Nov 25, 2017
Messages
3
I just bought a ranger with this 140 johnson. First time out it died on me and havent got it runnin since. The engine would crank just fine but couldnt get it running so i replaced plugs, coil packs, fuel pump, starter and impeller. Now it turns over 3 times in about 5 seconds which almost seemed like a battery problem but is definetly not. So upon pulling drain bolts for the carb bowls there was a water/gas/dirty mixture in them. After draining bowls i pulled the plugs and only the 2 on the left side of the block had water on them. I cleaned them off and blew compressed air in plug holes to dry up any excess wTer, returned plugs and the boat cranked wonderfully and even started right up. Then died again with the slow loping turn over like in the beggining until almost wouldnt turn over anymore at all. Went through that entire process again and same result. Started great , died and then barely turned over. I have done tbis process a few more times with same result. Its getting spark on all 4. Getting great fuel, clean gas ect. What could this possibly be? Head gasket possibly? Somehow when impellor was changed water is now getting into engine somehow? I just dont. Please help yall!
 

jbuote

Lieutenant Junior Grade
Joined
Aug 17, 2016
Messages
1,001
Not a pro here, but sounds like the first thing you should do now, is a compression test.
​Clean it out like before so it cranks over normally (not starting, just turning it over).
​Do the compression test,
Post those compression numbers here and then I bet you'll get pointed in the right direction..
 

Saltydog99

Recruit
Thread starter
Joined
Nov 25, 2017
Messages
3
So i have the compression readings if anyone can make sense of them. So from standing behind the engine top left side being 1 and below that 2 then right side top 3 and below 4. 1-100 2-130 3-120 and 4-115. Please help me out i need it.
 

jbuote

Lieutenant Junior Grade
Joined
Aug 17, 2016
Messages
1,001
Well,
The right bank is within 10% of each other, so that's good.
The left bank isn't..
​What you have listed as #1 appears to be low..
Well, They're all low I think, but runnable if they were all around 115-130...
​With your #1 being 100 I think the next step I personally would take would be to pull the head on that side and check the head gasket... Happens to be the side getting water too, so that fits....

Again, not a pro here, so you may want a second opinion on that, but that's what I'd be considering at this point if it were mine...
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
# 1 is top right-----# 2 is top left---#3 is bottom right.----Pull the head.----You be a lucky man if it is a blown head gasket !!!!
 
Top