1978 Johnson 9.9 water in motor housing

Outdoorboater

Recruit
Thread starter
Joined
Feb 27, 2017
Messages
2
I have recently bought a 1978 Johnson 9.9 that starts very quickly and runs fine. But I've noticed water inside the housing while it's running. Enough water at times to overflow out of the back with the cover off of the motor. Water comes out of the pee hole with a good steady stream and doesn't fade or slow down. My question is, is this normal for water to be in the bottom of the housing? And if not what do you think could be wrong?
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
All I can say is let it dry out and then take the cover off, start it up in a barrel or the lake and look for where it's leaking.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
quite a lot of water. The thermostat cover could be a culprit, particularly the bottom, or maybe the head or exhaust cover gasket. Maybe a freeze plug?
 

Outdoorboater

Recruit
Thread starter
Joined
Feb 27, 2017
Messages
2
Just a little update on what I found. I pulled the thermostat cover off and the thermostat was missing and the gasket was tore on the bottom side of it. I have ordered a new thermostat and new gasket along with a carb rebuild kit. Figured I would go ahead and clean the carb while I had everything tore apart to prevent future hiccups. Thanks for all of the input.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
sounds like progress. As you know from taking off the t.stat cover, the fit is very tight at the bottom. The best approach is to take off the head cover, and assemble the thermostat and gasket/cover on the workbench. You will need a head gasket, and should should resurface both the head and t.stat covers. To remove the head cover, back out the two bottom bolts half way, then lift out the cover. To replace, insert the lower bolts in the cover, then drop the cover in place. I use some sealant on the t.stat cover and gasket -- OMC/BRP gasket sealer is excellent and lasts forever (Don't use RV/silicone sealant.)

Resurfacing means laying out a piece of 400 grit sandpaper on a piece of glass or similarly flat surface, and moving the mating surface in a figure eight pattern until the shine is consistent all around the surface.
 
Top