1978 Johnson 25 throttle gear removal

Alabama gulf

Cadet
Thread starter
Joined
Apr 19, 2018
Messages
6
Hello I recently bought a boat motor that has a stiff throttle (on the tiller handle). The motor is a 1978 25hp 25r78c. I have narrowed the problem down to the throttle control gear part # 0387634. Any advice on removing the throttle control gear.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
The gear is held in place by the control lever and pin (the vertical piece that extends up to the throttle plate. You would disconnect the linkages at the top and remove the clamps that hold it to the powerhead (about half way down).

But it’s more likely that the stiff throttle control is due to issues with the grip or with the throttle/timing plate under the flywheel. I would start at the plate and see if you can move it by hand. Grease underneath can harden up making it difficult to rotate. Grip it with both hands and see if it can be rotated clockwise (should be able to do so). Put the motor in gear (engine off) so the plate can move through the neutral throttle stop.
 

Alabama gulf

Cadet
Thread starter
Joined
Apr 19, 2018
Messages
6
I have removed the control lever, the pinion and the gear shaft from the other side. The throttle control gear seems to be completely dicomected but is still very difficult to move back and forth.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Have you tried lubing it up. A good penetrating oil can sometimes loosen them up. I have also used brakencleaner to get the clean. Spray the penetrating oil at the base of the gear liberally and work. Then work the gear back and forth sometimes you can raise the gear a little to get the oil underneath it.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
This is what happened.-----Corrosion products have built up between the plastic bushing and the housing , this jams it up.-----Remove the gear.----Remove the bushing.---Scrape out the white powder.----Install bushing and gear.----Likely no lube required !
 
Top