1978 Johnson 150hp gear slipping?

b_roberts

Recruit
Thread starter
Joined
Aug 10, 2016
Messages
3
I have a 1978 Johnson 150 on a 24' pontoon I recently purchased. During the test drive she ran perfect. I took it out the next weekend and backed it off the trailer and was in reverse and was getting too close for my comfort to another boat coming in and shifted rather quickly to forward... Now she won't go past low throttle with out running the engine to WOT and no prop movement. I have already replaced the prop that it came with which was completely wrong for the boat and now have a new prop and hub in place. What else will cause the motor to do this? Any help will be greatly appreciated.
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Normally, it is advised to "thrust the shifter vigouously" when shifting between gears. So this normally is not a problem. Something is amiss for sure.
I'd want to verify that it can shift normally between gears in the gearcase. So disconnect the shift cable end under the engine's cowling. Once the shift cable is disconnected, start the engine and move the shift lever between gears with your hand. If it shifts normally by hand, that's good-means the gears and gearcase adjustment are probably ok. So the problem should be with the cable (out of adjustment) or in the control box itself. Adjust the shift cable end (eye) to meet the shift arm stud under the cowling when in forward and when in reverse. You adjust the cable end by turning/rotating the turnbuckle so the cable end moves in/out depending on what is needed to adjust the eye to meet the stud when in either gear. If you do adjust it and it still does not work, you may need to pull the control box apart and see if some nylon part inside is broken our out of adjustment.
 

b_roberts

Recruit
Thread starter
Joined
Aug 10, 2016
Messages
3
Thank you for the quick reply I will try this as soon as I can and let you know how it goes.
 

b_roberts

Recruit
Thread starter
Joined
Aug 10, 2016
Messages
3
Ok the linkage doesn't seem to be the issue. I found that I can put it in forward and fairly easily move the prop by hand...so my assumption is there is a gear somewhere jacked up???
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Betting on one if two things - either the driveshaft splines have spun out in the crankshaft or the driveshaft has broken. Is start by draining the gear oil and noting whether there's metal bits in if which would indicate a gear issue.
 
Top