1978 Islander 22 I/O

[IslandExplorer]

Wow, love the diamond plate and SS floor drains you added! They probably should have done that from the factory. That looks so clean. Might need a couple of those. Could rinse it right out if needed. Great work and thinking on that.

That under bench area is one of the louder in-cabin areas when anchored due to wave slap. Was on my Starchief at least anyways. I bet the choice to put foam in there will really help quiet it down when in there taking a nap on the hook.

 

[redneck joe]

Vinyl on the forward cabin bench. I guess they discontinued making Nautolex's glue. The Weldwood seems to be working fine.

i used weldwood with no problems

 

[66Holiday924]

Wow, love the diamond plate and SS floor drains you added! They probably should have done that from the factory. That looks so clean. Might need a couple of those. Could rinse it right out if needed. Great work and thinking on that.

Exactly! I'm thinking about long-term care, ease of cleaning and replacing. The idea with the garage flooring is for it to be a disposable option. I'm not gluing it in. When it is junk, take up the deck fittings cut a new piece and put it down. There's nothing to rot under the flooring. It's aluminum framing and coosa.

The garage flooring is expanding and contracting. When it gets really hot I have a wrinkle... Nothing too bad. When I put the rest in, I'm going to put it in while it's hot and see how that helps that out.

That under bench area is one of the louder in-cabin areas when anchored due to wave slap. Was on my Starchief at least anyways. I bet the choice to put foam in there will really help quiet it down when in there taking a nap on the hook.

I just figured that I have a whole cabin to use for storage. So, I took what storage I wanted out of the benches and used the opportunity to get an adequate amount of floatation foam in. Besides, in my experience, the under-bench storage isn't really that great. You end up putting stuff on the benches and have to move a bunch of stuff to get into it, and it ends up getting really dirty and grimy under there.

As I was doing it, I was thinking that it should help with sound. Aluminum boats can be loud.

 

[66Holiday924]

Port-a-potty flush handle access

 

[66Holiday924]

Floatation foam

When I did the demo on the boat I kept a huge hunk, about 2 cubic feet of styrofoam. I cut that up and incorporated it into my pour in expanding foam. I think it's cool when some of the original parts and materials can be put back to good use.

The last few pictures are of my bilge. I was looking to see if any foam "crept" in. Remember, I put down sheet vinyl across the ribs, so none of my expansion foam touches the hull. My thought is for water that makes it in through rivets that will inevitably leak, to give it a clear path to the bilge pump, instead of getting trapped and eventually rotting/waterlogging the foam.

I used HVAC tape to install the sheet vinyl. What an awesome friend it's been on this build! I advise anybody working on one of these boats to get a roll of that tape. It will come in handy here and there. If you're going to try the sheet vinyl in the bilge, it's the only way to go for installing that.