1978 115 hp Johnson outboard

govolsgo32@comcast.net

Recruit
Thread starter
Joined
Mar 18, 2016
Messages
5
Have 1978 115 hp Johnson seahorse outboard. Have rebuilt both carbs, replaced all coils, replaced power pack, replaced spark plugs. The engine is hard to crank and when it does crank it idles ruff and then back fires. Have checked the timing and it is right. What else could it be? I am at the end of my patience with it. Please help!
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Impressive list of work.----Have you removed flywheel to check the key, yes or no ?-------What does a compression test show on it ??
 
Last edited:

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,701
Does it backfire out of the carbs, or the exhaust?
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
After you check the flywheel key, double check to see that the spark advance link is connected between the spark advance lever and the timer base..
 

govolsgo32@comcast.net

Recruit
Thread starter
Joined
Mar 18, 2016
Messages
5
No I haven't checked the flywheel. I will do that and see what the compression is. It back fires out of the exhaust. I will also check the spark advance link. Thank you all so much for the replies.
 

slimdaddy45

Seaman Apprentice
Joined
Jul 11, 2007
Messages
45
Take the big nut off on top of it and look to see if the slots are lined up that is the key does if it is sheared the slots will be off from each other HAS A SLOT IN THE SHAFT AND THE FLYWHEEL THEY MUST BE LINED UP if the nut is not real tight that can cause it break
 
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Post # 8 is NOT correct !-----When you pull the flywheel off the key is in a groove on the crankshaft.--Now it is NOT a standard woodruff key.------------The key locates the flywheel for proper timing of the spark.------The flywheel is actually driven by the locking tapers when flywheel nut is torqued to 100 FT-LBS.
 
Last edited:

slimdaddy45

Seaman Apprentice
Joined
Jul 11, 2007
Messages
45
Make sure the butterflys in the carbs are sync'ed if one is open just a bit it will make it pop mine did this I adjusted the linkage to where both butterflys were closed and it quit poping or backfireing dont take much so if you had the carbs off maybe you dont have them adjusted right
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,701
You haven't got the wiring to the coils crisscrossed?
 
Top