1977 25hp loses drive at higher throttle

mshogman

Recruit
Thread starter
Joined
Jun 13, 2016
Messages
3
My 25 hp Johnson has developed a problem. Engine runs good but when turning throttle up to approximately half or higher it's like the prop jumps out of gear and rpm rev way up. I immediately turn throttle down and it reengages but will only operate properly at about quarter to half throttle. Shift lever is not jumping out of gear but that's what it acts like. I've drained and refilled the lower unit but it didn't help. Any help would be greatly appreciated.
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
Could be a slipping propeller drive hub. You can take the prop off, make a mark across the spline to the outside edge, run again, remove and inspect. If the line doesn't align it's slipping.
 
Last edited:

Hezekiah

Petty Officer 3rd Class
Joined
Feb 23, 2015
Messages
93
Kind of sounds to me like you are having ventilation issues. Do you have your motor installed at the proper height?

I was having the same issues with a 25hp - the motor would get going good, but once I got a little speed, one of the ridges on the bottom of the boat was creating a ventilation with the prop - I dropped the motor down 1" on the transom, and it fixed the problem.

I also thought it was a spun hub at first.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Could be a slipping propeller drive hub. You can take the prop off, make a mark across the spline to the outside edge, run again, remove and inspect. If the line doesn't align it's slipping.
Excellent advice, but save yourself some light work. You don't have to remove the prop. Just mark the prop nut and an adjacent mark on the prop. The nut turns with the shaft and hub if/when it slips.
 

mshogman

Recruit
Thread starter
Joined
Jun 13, 2016
Messages
3
Great advise I thought the same thing about the prop being the issue but then realized this motor does not have splines. It has a sheer pin. As far as ventilation I have the motor all the way down on transom and the adjustment height is at is lowest setting. It does sound like the prop is blowing out but I have reved it up on the trailer in a clear lake and verified it stayed in the water and still had the issue. Any other ideas would be appreciated. I've got 2 son's wanting to go fishing this weekend.
 

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
The hub inside the prop is what may be slipping and it makes no difference how it is attached to the prop shaft.
 
Last edited:

mshogman

Recruit
Thread starter
Joined
Jun 13, 2016
Messages
3
Thank y'all very much. I did pull prop and made a mark, reinstalled and ran engine in a barrel. It reved up and when I pulled prop back off the mark was in a different place. I've ordered another prop to be here Friday. Thank y'all very much, this is much better than the lower unit I was afraid it was.
 
Top