1975 Johnson 70 HP No start

1975Muskie550

Recruit
Thread starter
Joined
Jul 21, 2018
Messages
3
Hello,

I have a 1975 AMF Crestliner that some friends and I restored. We finally finished this bad boy up and today we finally went to take it out. Once we backed it up in the boat launch and tied it up and got in, we tried to start it. It didn’t start. As we worked on the boat we started it 4 or 5 times. It started every time. We did have to replace the starter in order for it to start. We put the earmuffs on it ran the water through it and it purred pretty well. What irks me is that we couldn’t get it started in the water. My friend and his dad are starting to float towards a cracked head because the exhaust looks like it’s brown and dirty. What I’m thinking is that it hasn’t ran in ten years and we didn’t get it to start and when the water mixed with the gas and oil it made it look dirty. They are saying there is no spark because water is getting in there somehow from being pumped through the engine. They said they followed some instructions on a bottle and it said for a 50:1 mixture you put 3oz for every gallon but I looked it up and it’s like 2.5oz per gallon according to some calculator. Could it just be the gas mixture? Or is a cracked head the only explanation?
 

1975Muskie550

Recruit
Thread starter
Joined
Jul 21, 2018
Messages
3
I forgot to mention that the trailer detached from the hitch of the truck and slammed into the ground. Could that have knocked a valve shut? Where is the reed valve?
 

BassinGas

Cadet
Joined
Jun 27, 2018
Messages
14
Reed Valves are behind the carbs, you have to remove carburetors to get to them. When you say you worked on the boat, what did you do? Compression check? Spark Check, Carb rebuilds? Any engine work other than starter?
 

1975Muskie550

Recruit
Thread starter
Joined
Jul 21, 2018
Messages
3
The compression is kind of low. When it cranks it spins like wild with no resistance. But before today it started no problem. This morning they turned it on for a second just to check. We did a spark test on one spark plug and it sparked. They are breaking down the motor now. We didn’t rebuild the motor at all. We changed the starter, plugs, gear oil, and fixed up the boat itself mostly. New floor, new carpet, fiber glassed the floor, new seats new vinyl, and reupholstered some other seats in the front of the boat. They suspect most of the rubber parts are dry rotted and were trying to find the reed valve before giving up tonight. Working on outboards is so hard. These two are like car geniuses and I know they will figure it out, but they sure did make it really hard to work on them.

I told him that the reed valve is under the carburetor. Thanks for letting me know. Maybe it’s stuck shut or something.

As for restoring the engine where would I find stuff to do that? It was so hard to find the starter I found and it works like ****. Sometimes it doesn’t engage and we have to tap it until it engages lol. We had a zip tie on there and it worked but they cut it off today and replaced it and now it doesn’t work the same.
 
Top