kazper
Recruit
Thread starter- Joined
- Jun 5, 2011
- Messages
- 1
Haven't followed in a while, as I am planning getting back into boating/fishing this summer. Long story short, I own a 1979 fibreglass Tri-hull with a 1978 Johnson 55 hp outboard with a bad lower leg. I just recently purchased a 1975 Johnson 50 hp outboard to replace the 55 hp. I have been looking online to find some sort of comparison between the two and have come up with nothing. I appeal to the Johnson outboards guru's here to help me out!! What is the difference between the two engines? What was done to the engines to gain the extra 5 hp? I need the lower unit for my 55 but I was planning on just changing the entire engine but would like to keep the 55 powerhead for parts because it ran very well.
What's held me back on the 55hp repair so far is I cannot, CANNOT get the lower leg to split for the upper unit on the 55 to rebuild the lower leg. Yes I gave up on that and parked the whole works in the quonset out of plain fustration!! All bolts removed, linkages and other stuff disconnected, but I think the shaft is siezed in the crankshaft. Any help would be appreciated. Thanks in advance!!
Karl
What's held me back on the 55hp repair so far is I cannot, CANNOT get the lower leg to split for the upper unit on the 55 to rebuild the lower leg. Yes I gave up on that and parked the whole works in the quonset out of plain fustration!! All bolts removed, linkages and other stuff disconnected, but I think the shaft is siezed in the crankshaft. Any help would be appreciated. Thanks in advance!!
Karl
Last edited: