1975 Johnson 40hp engine not staying started

Kurban2

Recruit
Thread starter
Joined
Jul 18, 2016
Messages
2
Hi,
I just recently bought a boat, trailer, and engine. After getting new gas with a 50-1 mixture and putting muffs on it. The motor will start for a couple seconds then die. Choke has to be on to even get it started. The only other thing I've noticed is fuel leaking from the carb whenever the bulb is pumped. I'm wondering what is wrong with it and what can I do to fix it and get her running. Thanks
 

joeanna

Petty Officer 2nd Class
Joined
Jun 5, 2016
Messages
108
clean the carbs, sounds like it has been sitting for a little while
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
^^Carbs have a hinged bowl float and a needle valve assembly to control fuel level. Parts have to be squeaky clean. It's a DIY job, if a little challenging the first time.
 

Kurban2

Recruit
Thread starter
Joined
Jul 18, 2016
Messages
2
I was told the motor has been sitting for about a year and the whole thing looks pretty clean. I was told to clean the carb but when someone looked at it they said it looks pretty clean.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
i turn the carb upside down and then i try to blow in the fuel intake, if it takes air then your valve is stuffed.
Otherwise the float can be bad, they sometimes lose their floatation strength and thus dont shut the fuel flow off.
I also bend the tab on the float so it shuts off the valve just before the instructions say to set it at. Which is normally said as level with the carb bowl

Definitely clean the carb as stated above.
Looking at one is like doing medicine without a scan, you will miss where most of the action is
 
Top