1975 Evinrude 25hp Throttle Gear Assembly

64fyermun

Cadet
Thread starter
Joined
Jan 23, 2016
Messages
8
imagesW76U1DA9.jpg

Does anyone have any advice on how to loosen up this piece/remove it for cleaning? I was able to remove the rod that comes in the tiller handle and the gear piece attached to it. This piece is still extremely tight and hard to move. Is there a way to loosen it up with the set screw? I have lubricated it several times and worked it back and forth, but it doesn't seem to help. If my phone quits being hard to get along with, I will try and take a picture tonight.
Thanks
Tee

PS. I borrowed this picture off of the internet, it is not my actual part but looks exactly the same.
 

AlTn

Commander
Joined
Mar 9, 2010
Messages
2,813
you'll need to remove the vertical shaft that fits into that assembly < easy to do >...motor in fwd gear, twist the grip to wot, remove the ss clip at the top of the shaft that prevents the armature arm and vertical shaft from slipping apart...remove the clamp that holds the vertical shaft upright and attached to the side of the motor block < 2 straight slot screws >...vertical shaft can now be pulled upward and removed from the Throttle Gear Assm...if the rubber "accordion" piece is still in place you can either remove it or just pull the shaft through it...with the shaft out...examine the "ears" that fit into the slot of the throttle gear assm...this piece is replaceable if it's damaged...also...check the movement now in that throttle gear assm. and also check the movement of the armature plate using that arm that you disconnected the vertical shaft from...either one may be causing your binding
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
As I read it, your gear is stuck in the steering bracket, right? That is a common situation, caused by corrosion around the outside diameter of the nylon bushing that it fits into.
Remove the vertical control shaft as described above. Also, the horizontal gear/shaft assembly which you seem to indicate is already out. Now look under the steering bracket and you will see the bottom end of your gear. Use a suitable tool to knock it upward and out. Yes, it will be tight, but will move with enough force. Now with the gear out, remove the nylon bushing the same way. It might not survive, but usually does. With the bushing out, clean the corrosion out of the hole that it was in. Lube everything liberally with a good waterproof marine grease and reassemble.
 

64fyermun

Cadet
Thread starter
Joined
Jan 23, 2016
Messages
8
I just wanted to thank you for your help. I was able to get everything taken apart from the armature plate to the handle on the tiller. I was able to clean and grease everything, and amazingly, was able to get it all back together. It is working just as smooth as the day it was made. I am looking forward to hopefully trying to start the motor tomorrow. I have a really good feeling about resurrecting this thing. I appreciate everyone's help. By the way, just in case it does start, what was the original color of the top of the motor color. It looks tan, but I feel like it was the same metallic blue as the rest of the motor. Thanks. Tee
 

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
No Title

If you are asking about the color of the cowl. The motor in the picture is one I found and I think it is a 1975.
 

Attachments

  • photo238137.jpg
    photo238137.jpg
    57.9 KB · Views: 0
Last edited:
Top