1974 Johnson 25 - no forward

SouthShoreGuy

Recruit
Thread starter
Joined
May 2, 2016
Messages
5
I rebuilt the lower unit and reassembled. Have forward and neutral but no forward. What is best next step ;;; linkage screw??? visually the forward gear and dog seem fine. Happy to repay advice in kind.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Are the notches on the shift rods lined up with the holes in the brass connecter ?-------Did you put clutch dog into the forward gear and push shift rod towards powerhead before putting the cap on ?-----Are you sure the pivot pin is in the hole on the shift fork ?
 

SouthShoreGuy

Recruit
Thread starter
Joined
May 2, 2016
Messages
5
I did not put clutch dog into the forward gear and push shift rod towards power head .... there is only one notch on lower rod and not certain it is lined up with holes . I am sure the pivot is the hole on shift fork. Beyond thank you ... I have spent a fair bit of time on project. I am a decent wrench on cars but have little to no experience with boats. Thank you thank you thank you.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
??--There is one notch in the upper shift rod and one notch on the lower shift rod.
 

SouthShoreGuy

Recruit
Thread starter
Joined
May 2, 2016
Messages
5
Would really like to just pay someone to do for me as I am nearing end of my patience.
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Going to disassemble and put dog into forward gear ... I didn't do that.

Don't disassemble it just yet. Just drop the L/U and pull the shift rod up. Turn the driveshaft clockwise and observe the direction of prop rotation. Push the shift rod down and the direction of prop rotation should reverse. With the shift rod in the middle, you should have no prop rotation. If so, then the gearcase is fine. Put the L/U back on and make sure the bolts in the shift rod coupler pass through the shift rod recesses.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
There is no adjustment in the gearcase.---There is no adjustment at the connecter,--Therefor the adjustment is found at the shift handle.----You might want to look into that adjustment.
 
Top