1974 115 hp johnson weak

Mr.Lang

Recruit
Thread starter
Joined
Aug 15, 2016
Messages
5
Was out for a run after replacing the fuel system, coils, and plugs... was running very weak but would power up if i trimmed it till the prop almost came out of the water... then it spun the prop on the way back in... middle of the lake, nothing wrapped and nothing to hit... what would cause this? Can the problem be in the foot?
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
What's the compression? If you had the carbs off, did you make sure the linkage was properly synchronized to the timing advance? Carbs opening fully?
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
Sounds like your engine is down on power. Any engine needs max power when the prop is 20" underwater. The engine needs all it's hp to spin a prop underwater, and to blow the exhaust down the tube and out the prop. Once the prop gets closer to the surface of the water, it takes less hp to spin the prop and to push the exhaust out of the prop. Possible your engine is not running on all 4 cyls. Check for spark on all 4 plugs when running it on the lake.
 
Top