1973 johnson mate 2 only starts in high

dmm26

Recruit
Thread starter
Joined
Aug 21, 2017
Messages
3
Hey All!

I'm not super familiar with outboard motors and have this mate 2 that only starts in high with no choke. I try to throttle down and it just dies immediately like its been put in the stop position.

The carb is all cleaned out and kit installed, needles set at start position, and everything else seems to work fine but there's no throttle other than high.

Is it points possibly?

Any help appreciated, not scared to rip it apart.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Welcome!

It sounds like you may want to start over again. The coil will need to be replaced if the casing is cracking. I would just replace points and coil at that point.

The carb needs to be disassembled and soaked, then all small openings cleared with soft wire and carb spray. The domed cap on top needs to be removed for access to the idle passages. Additionally, the nozzle running vertically has to be removed and cleaned, with special attention to the small holes in the nozzle.

The tank may have some varnish build up, and the valve often needs to be removed and cleaned.

Replace the plug wire if it's old and brittle, using 7mm solid core. Pay special attention to the clip in the spark boot and the connection at the coil.

Just standard stuff, but important to bring a motor back into shape. The gearcase has a rubber impeller that needs to be replaced (good place to start, as you don't want an old impeller to break up and clog cooling passages.)
 

dmm26

Recruit
Thread starter
Joined
Aug 21, 2017
Messages
3
Thanks for the tips!
I'll tear it apart and get new parts.
 

dmm26

Recruit
Thread starter
Joined
Aug 21, 2017
Messages
3
I went ahead and replaced the coil, points, condenser, and re cleaned the carb. It's got fuel, spark and compression. It sounds like it wants to go and will fire up but only for a moment and dies.

I think it may be the magneto air gap. I'm not sure how to set that properly as there doesn't seem to be a way to measure before putting flywheel back on.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Air gap will be correct if the coil is set perfectly flush on the mounting boss. Have to tried to fine tune the air mix yet? It's usually a bit leaner than the initial setting.
 

ondarvr

Supreme Mariner
Joined
Apr 6, 2005
Messages
11,527
You said the compression is fine, what is it? These motors don't run well at low RPMs when the compression is low.
 
Top