1973 Johnson 50hp Not cranking

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
?????????????????????????????????I am trying to say what was said in post number 15 was not correct in my opinion. Not everybody knows everything about everything like you think you do. you can lay down your ?????????? all day but that does not mean you convince me. I have two motors with the exact same switch and all it does is supply ground to the solenoid. There is a piece attached to the gear shift that pushes in the plunger on the switch. In this case you said it is for not too much throttle, so I assumed something would push in the plunger to supply a ground to the starting system. ???????????????????????????????????????? Okay now you you can tell me how I am wrong and you are right????????????????????????????????????????????????????
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
In post # 17 says there is no voltage going through this switch.---But it has a wire going to it and it is called a switch ?
 

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
All I know is if the wire that goes to the switch is grounded then the switch is not needed to complete the circuit so I thought it was just a ground. But you have made it clear that whatever you say is right. So you win and I have no idea about it.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The original poster replaced his solenoid , replaced the key switch.---Still did not work.---------He then found out that a simple adjustment / cleaning of the second safety switch on the side of the motor was the solution.----Success !
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
Racerone...

I looked up the selenoid and effectively it has 4 connections IN +12V for the battery supply.... OUT +12V to the starter when asked to crank by the start key

the 2 other small posts could only be IN +12V coming from the start key when....starting

and that funny hook up to frame ground via the " to much throttle" safety device. AKA "safety switch on the side of the motor"

no need to assume the modern convention that it is negative battery that flows to the positive which in this case would imply that the "negative ground" does the work by flowing backwards to the start key

most of us assume +12v flows to the negative post (via the engine body) . With that electrical "convention" in mind the start key +12 does the work of energizing the selenoid pull up coil via... the safety switch


I stand corrected :-(
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
not available to me...

but in essence, there are only so many ways to skin a cat and a safety switch on the ground side of the selenoid is one of them and to my knowledge most engines if not 100 % (outborads and inboards) ...... all work with negative ground like most cars .

but surely some exceptions exist out there

the RDS 22 layout does show a mercury switch and a cut out switch... both is series with the engine frame ground to
prevent engine cranking
 
Last edited:

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
mjaj -- Find a model specific wiring diagram online. Just google make, model number, hp -- will get many hits, as well as leads. Do a search here on iBoats.
 
Top