1973 Johnson 115 - Impeller Replacement

shoola

Recruit
Thread starter
Joined
Jul 12, 2003
Messages
2
We need some advise on how to remove the shift linkage so the lower half can come free and we can get to the impeller. Everything is unbolted, but this is the only thing holding us up! Help!!! Thanks everyone! :eek:
 

OBJ

Supreme Mariner
Joined
Dec 27, 2002
Messages
10,161
Re: 1973 Johnson 115 - Impeller Replacement

Hi shoola and welcome to the forum...<br /><br />Look below and to the rear of the bottom carb and you will see two parrallel "arms" connected to the shift shaft. The arms are held in place by a large bolt. You will need to loosen this bolt to disengage the shift rod pin. Back the bolt out just enough to disengage the pin and be careful not to turn the shift rod after the lower unit is removed. The shift rod height is adjustable. Measure the height with the gear case in neutral and check again before installation.
 

shoola

Recruit
Thread starter
Joined
Jul 12, 2003
Messages
2
Re: 1973 Johnson 115 - Impeller Replacement

Installed the impeller and still no water... I'm thinking thermostat, blockage or both? If so, where's the thermostat located and any methodologies for proper replacement is greatly appreciated! Thanks for the previous advise, worked great!
 

Solittle

Fleet Admiral
Joined
Apr 28, 2002
Messages
7,518
Re: 1973 Johnson 115 - Impeller Replacement

Shoola - The best suggestion I can give is to get thje OMC shop manual for this. I have 1987 V4s so they mine may not be the same as yours. Look at the base of the heads. There will be a hose for each head that goes to the thermostat cover. If yours is like mine the job is a bit of a bit$h as you do not have easy access to the bolts. I dropped the pan at the base of the motor to get a box wrench in from underneath.
 
Top