hillbilly34207
Recruit
- Joined
- Jun 18, 2012
- Messages
- 1
I am new to this forum and need some advice. I recently started tearing down a 17' Proline. I am going to post what i have so far and questions that i have before i go on.
So what i have done......
1. Removed all electrical
2. Cut out console
3. Found a whole lot of rot and a fuel tank that i didn't know was there
4. Removed outboard
5. removed rub rail and drilled out rivets
So now i am stuck. I want to remove the cap to replace the stringers and transom, But where do i separate the floor from the cap. Do i cut along the 90 where the floor meets the side of the cap? i will try to get pictures on here as much as i can. Any help would be appreciated.
Thanks
Jason
So what i have done......
1. Removed all electrical
2. Cut out console
3. Found a whole lot of rot and a fuel tank that i didn't know was there
4. Removed outboard
5. removed rub rail and drilled out rivets
So now i am stuck. I want to remove the cap to replace the stringers and transom, But where do i separate the floor from the cap. Do i cut along the 90 where the floor meets the side of the cap? i will try to get pictures on here as much as i can. Any help would be appreciated.
Thanks
Jason
