lanthony2020
Cadet
- Joined
- Jan 9, 2015
- Messages
- 6
Hello, I am restoring a 1972 Land N Sea houseboat. It came with two 1972 OMC Stringer drives, GUFM-10S. I have purchased new balls gears and shafts including new bearings, gaskets, etc.. Not together yet. I have hydraulic steering. The tilt motors are also new.
Question: The top of the intermediate housing, there is a cover bolted down, I cannot seem to get the screws loose to take the entire unit apart. What important function other than the shaft, tilt motor, steering, does the intermediate serve? What is inside here that I need to pay attention to? I know the exhaust runs through this as well? Anyone know? Is it necessary to take this all apart?
Thank you in advance.
lanthony
Question: The top of the intermediate housing, there is a cover bolted down, I cannot seem to get the screws loose to take the entire unit apart. What important function other than the shaft, tilt motor, steering, does the intermediate serve? What is inside here that I need to pay attention to? I know the exhaust runs through this as well? Anyone know? Is it necessary to take this all apart?
Thank you in advance.
lanthony