Just to clear the air, I am new to owning a boat, this is my first. Evinrude model 65273S.
Initially I bought the motor from a guy (he started it up for me before I bought it) and he told me that the motor ran, but the top coil wasn't working. He had replaced the coils and traced it back to the stator. I took the boat out on the water after making sure it would run once I was home and it seemed to work ok, just wouldn't accelerate above half-throttle even if I opened it up all the way. So I pulled the flywheel and looked at the stator, it had some brown goo coming off of it a little, so I bought a new aftermarket one and installed it.
Then the motor wouldn't start at all. I looked at the spark plug, not getting a spark, replaced it, still not working. I looked at the top coil and no juice, replaced it and still not working, I looked at the power pack and no juice going to top coil connection, replaced the power pack this morning and all I get is a backfire from the engine when I turn it over.
I think the battery was getting worn down from all my testing, so I am charging that while I am at work.
Any ideas as for why it is only backfiring and not starting? Could I have damaged something when pulling the flywheel?
Initially I bought the motor from a guy (he started it up for me before I bought it) and he told me that the motor ran, but the top coil wasn't working. He had replaced the coils and traced it back to the stator. I took the boat out on the water after making sure it would run once I was home and it seemed to work ok, just wouldn't accelerate above half-throttle even if I opened it up all the way. So I pulled the flywheel and looked at the stator, it had some brown goo coming off of it a little, so I bought a new aftermarket one and installed it.
Then the motor wouldn't start at all. I looked at the spark plug, not getting a spark, replaced it, still not working. I looked at the top coil and no juice, replaced it and still not working, I looked at the power pack and no juice going to top coil connection, replaced the power pack this morning and all I get is a backfire from the engine when I turn it over.
I think the battery was getting worn down from all my testing, so I am charging that while I am at work.
Any ideas as for why it is only backfiring and not starting? Could I have damaged something when pulling the flywheel?