1971 johnson 60 hp wont turn over

stephen.gibbo

Cadet
Thread starter
Joined
Mar 21, 2016
Messages
7
I have a 71 johnson 60 hp i just got that wont turn over at the ignition switch. Replaced solenoid and ignition switch. When i hook a jumper cable straight to the starter it turns over, however it seems theres alot of compression like it's still in gear but the lever is in the neutral position. Could the reason it isn't turning over because its not switching out of neutral so the neutral safety switch wont let it turn over. Please help
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Could be a bad neutral switch/ignition switch or bad wiring harness. Should be able turn over in gear sounds like an electrical problem make sure all the connections are clean and tight. Make sure the battery is good.
 
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Fact----That motor will be in forward gear when it is not running.----------It kicks into nuetral after the starter turns it about one turn of the crankshaft.-------Look for a safety switch on the engine block.-----Has a white wire to it.----------If throttle is advanced too far motor will not crank.------If switch is durty it can be cleaned.-----I clean them even if some say " it can't be done "
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
It sounds to me like your starter could be due for cleaning and rebuilding. I hear you saying it turns over slowly (reference to high compression) -- think that was while jump starting. You might pull the plugs and crank it again with the jumpers. If there is a clear difference (cranks a good deal faster without plugs), your starter may be failing. As a next step, you might then pull the starter, clean it up and replace the brushes -- or take it to a shop if you prefer. Have them bench test it, then rebuild as necessary.

There may be another of other issues, of course (above). But from your description it sounds offhand like you may have a weak starter. (JMO)
 

stephen.gibbo

Cadet
Thread starter
Joined
Mar 21, 2016
Messages
7
I would agree it could be a bad starter but why would i not be getting anything at all when trying to start it at the switch
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Bad ignition switch or problem in the harness or a bad solenoid or neutral safety switch
 
Last edited:

stephen.gibbo

Cadet
Thread starter
Joined
Mar 21, 2016
Messages
7
Not yet, im out of town on business and hotting hit hard on the motor when i get back. The plan is to bypass the neutral safety switch with a jumper and trying that and also checking the stsrter
 
Top