Hello. I have a 125ESL71C serial J3518101 with ignition troubles. I have the seloc manuel and have ran through their tests for toubleshooting CD Ignition. First is there a better manuel for this motor and where can I get it. Second, I think I have a bad power pack. Let me start by saying that this engine had sat for a while( i am guessing 2 years) and mice had gotten under the cowl and chewed some of the insulation from the wire. I tried the test I found here on line with the bulb and at first it was blinking. Changed plugs and the engine fired for a short burst 4 or 5 times. I checked for spark with an inline tester and found 2 and 3 firing 1 and 4 not firing. Removed flywheel and checked everything couldn't find anything major there. I did find where a mouse had chewed the insulation from the wire from the sensor. repaired with liquid tape. Checked sensor resistance 5.2 ohms. The powerpack cover had been damaged before and removed, so I removed it again and moving the black ground wire near where it goes into the gel? incapsulation (it's pliable) I heard a spark and the engine fired one of the cylinders. A new power pack is a lot of money but not if I can get this running. Its on a Hydrosport 178VEE. Just wanted to get someone's opinion of where to start or if I am on the right track. A schematic of the pulse pack would be helpful. Thanks for any help.
