1971 Evinrude 25 Help Please

EvinrudeMadness

Recruit
Thread starter
Joined
Aug 5, 2016
Messages
5
I have a 1971 Evinrude 25hp that wont start. I have replaced the points, coils and condensers. I have rebuilt the carb except I have not removed the aluminum plugs in the carb. I do have spark. I tested the fuel pump and it will spurt gas when I pull the recoil. I have 105 psi and 110 psi compression on the cylinders. The plugs appear to be dry even thou my arm is soar from pulling it over with the choke on. Any help would be much appreciated.
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Have you tried spray a bit of gas/oil directly into the carb? If it fires, then you have to determine if gas is getting to the carb, is the float set correctly, and are all the gaskets in place? One that gets forgotten a lot is the one that seals the main nozzle opening, it used to be part of the bowl gasket, later kits have it as separate gasket. If missing the fuel bowl is vented to the carb venture and will never supply fuel to the circuits
 

EvinrudeMadness

Recruit
Thread starter
Joined
Aug 5, 2016
Messages
5
Thanks for the idea. I am going to try it today to see if I can get it to fire. I am thinking I better remove the aluminum plugs on the carb also and see if the circuitry is plugged? The carb looks really clean but I suspect something could be plugged inside.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Obstruction under that plug will mess up the idle, but it wont keep it from starting. Did you look closely at the high speed orifice plug in the carburetor bowl? It must be absolutely clean and lots of people don't even realize it is in there.
 

EvinrudeMadness

Recruit
Thread starter
Joined
Aug 5, 2016
Messages
5
Would that be the jet you access through the drain plug at the bottom of the carb bowl? I blew air through it but I did not remove it. With all the cranking with the choke on you would think it would be flooded by now. Plugs have been dry. It puzzles me and I have never had this issue before. Thanks
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Check the choke detent.----Holds the choke closed when cranking it over.
 

EvinrudeMadness

Recruit
Thread starter
Joined
Aug 5, 2016
Messages
5
Well I finally got my 25hp Evinrude running today. After reading your post I took the carb completely apart once again. This time I took a drill bit and ran it through the main jet follow by carb cleaner and then air. I checked the needle and seat again and of course the float. I reassembled the carb and installed it back on the motor. The motor started on the third pull. Unbelievable! Thanks for all the helpful hints.
 
Top