I want to replace water pump impeller but there is little information on pulling the hydro-electric shift control wires down through the exhaust housing.
There appears to be a rubber grommet on the cable sleeve passing through the exhaust housing. Service manual says to "soap sleeve and pull through" as lower unit is being lowered. Manual tells you to "do it" but not exactly "how" to do it.
Manual says to pull outer exhaust housing, but it does not appear to be in the way???????
I do not want to damage or break sleeve or wires. How much force will "pull" wires through housing? Should attempt be made to push grommet through exhaust
housing with small tool before starting the drop and pull? Any advice from someone that has done this will be appreciated. Thanks.
There appears to be a rubber grommet on the cable sleeve passing through the exhaust housing. Service manual says to "soap sleeve and pull through" as lower unit is being lowered. Manual tells you to "do it" but not exactly "how" to do it.
Manual says to pull outer exhaust housing, but it does not appear to be in the way???????
I do not want to damage or break sleeve or wires. How much force will "pull" wires through housing? Should attempt be made to push grommet through exhaust
housing with small tool before starting the drop and pull? Any advice from someone that has done this will be appreciated. Thanks.