1971 60 HP won't start after repair.

Goneflying

Cadet
Thread starter
Joined
Apr 20, 2016
Messages
10
Hey guys,

So I recently replaced the exhaust adapter on my 1971 60 hp Johnson. I put everything back together and went to test it and got nothing when I turned the key. I am getting power as the choke solenoid is activating when I turn the key on, but nothing when I turn to start. Any ideas on things to check or adjust would be much appreciated.

- Josh
 

gm280

Supreme Mariner
Joined
Jun 26, 2011
Messages
14,605
You stated that you have nothing when you turn the key. Does that mean that the starter solenoid isn't kicking in? If so are you getting voltage to the small terminal at the starter solenoid when the key is turned? If there is voltage there and the solenoid isn't clicking in, check for a ground issue from the other small terminals or even a neutral safety switch not set correctly or bad. If everything is still wired correctly and this just started doing that, I would seriously look a the neutral safety switch out of sync.
 

Goneflying

Cadet
Thread starter
Joined
Apr 20, 2016
Messages
10
I checked and I have no current to the starter solenoid when the key is turned to start. Any idea's where a neutral safety switch would be located?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
On the side of the motor block near the throttle arm.----White wire goes to it.--- That swotch can be cleaned if need be.---Or back off the throttle and see if it cranks.
 

Goneflying

Cadet
Thread starter
Joined
Apr 20, 2016
Messages
10
I found the safety switch and cleaned the connections. Still nothing. I checked and I have 12v at the safety switch when the key is turned to start.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Take the white wire off that switch and have your assistant hold that wire to ground.-----Will the motor crank over now ?
 

Goneflying

Cadet
Thread starter
Joined
Apr 20, 2016
Messages
10
That did it! I'll get a new switch ordered right away. Thanks for the help guys!!
 

Goneflying

Cadet
Thread starter
Joined
Apr 20, 2016
Messages
10
So new problem, it seems the safety switch is doing its job because the motor is stuck in forward or reverse. I'm guessing the issue would be with the neutral shift solenoid. Any ideas if it's just a wiring issue or the actual solenoid?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
When the motor is NOT RUNNING it will be in forward gear.----Motor needs oil pressure in the gearcase in order to shift.----When cranking a good lower unit will shift to nuetral after one turn of the flywheel !
 

Goneflying

Cadet
Thread starter
Joined
Apr 20, 2016
Messages
10
Is there a place to add oil to this motor? It says on the throttle it has hydro electric shift.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
You don't add oil to the engine, you add it to the gear case (the lower unit).
 

Goneflying

Cadet
Thread starter
Joined
Apr 20, 2016
Messages
10
Sorry that's kind of what I ment by motor, I know the actual motor is a two stroke. I'm assuming I'll have to take the lower unit off now, will it be obvious where to add oil? And what kind of oil should I use?
 
Top