Hi Guys,
Been reading a lot off this forum since I bought new project 3 weeks ago.
It is a Wellcraft airslot 165 early 70's model. With the evinrude 50573b 50 hp. When I bought it the engine did not run cleaned out the carbs and changed all the fuel lines and now it runs great. It floats, but the hull is not pretty I would like to clean it up(sand and paint?) not sure how to do that.. Also I need to take the cap off the hulll so I can rebuild the wood floor underneath its definitely rotted out and has ton of drill holes in the fiberglass floor..
So I need a few suggestions if possible on.
1)Good fiberglass repair techniques as well as products(interior and exterior).
2) How do I separate the hull from the cap?
3)Repair of floor underneath? What type of plywood? Any tips possible.
4) Repairing the fiberglass floor holes as well as mounting new chairs.. Planing on doing back to back lounges..
Thanks Ahead of time
Ben
Been reading a lot off this forum since I bought new project 3 weeks ago.
It is a Wellcraft airslot 165 early 70's model. With the evinrude 50573b 50 hp. When I bought it the engine did not run cleaned out the carbs and changed all the fuel lines and now it runs great. It floats, but the hull is not pretty I would like to clean it up(sand and paint?) not sure how to do that.. Also I need to take the cap off the hulll so I can rebuild the wood floor underneath its definitely rotted out and has ton of drill holes in the fiberglass floor..
So I need a few suggestions if possible on.
1)Good fiberglass repair techniques as well as products(interior and exterior).
2) How do I separate the hull from the cap?
3)Repair of floor underneath? What type of plywood? Any tips possible.
4) Repairing the fiberglass floor holes as well as mounting new chairs.. Planing on doing back to back lounges..
Thanks Ahead of time
Ben