1970 johnson 25hp throttle issue

Robherold85

Recruit
Thread starter
Joined
Jun 19, 2016
Messages
2
So here's the deal, I got a 70 25hp johnson motor. She runs like a top no problems starting or staying running. The only issue I have is when backing down from full throttle it's all or nothing! It goes from wide open to idling no matter how little I move it. Any ideas on a fix? Thanks in advance

FYI no steering to throttle linkage
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
Can you accelerate gradually?
Have you checked nothing is sticky with the throttle linkages for the timing and butterfly
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Ignition coil dragging on the flywheel magnets??
 

Robherold85

Recruit
Thread starter
Joined
Jun 19, 2016
Messages
2
No problems accelerating. It's just after its been full throttle and back down.
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
Have a look when the motors off. Check that turning the throttle to slow only slowly closes the butterflyvalve and then the timing
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
No Title

Ignition coil dragging on the flywheel magnets??
Perhaps you didn't understand my suggestion. If the coils are rubbing on the flywheel magnets, the rotation of the flywheel is constantly trying to rotate the armature plate (throttle) toward "Slow" or "Stop". While you are holding the throttle the throttle at "Fast", you are resisting that rotation effort on the armature plate. As soon as you back off from "Fast", you stop resisting that rotation of the armature plate and it spins around toward the "Slow" position.

See the heat marks on the ends of the coils, caused by friction of rubbing on magnets
 

Attachments

  • photo2609.jpg
    photo2609.jpg
    93.6 KB · Views: 0
Top