1969 evinrude 6hp outboard, what to do next?

parksy100

Recruit
Thread starter
Joined
Apr 11, 2017
Messages
2
I picked up a 1969 evinrude 6hp outboard engine. I installed a new fuel pump, new fuel lines, carb kit, plugs, and purchased a new gas tank. I have spark, I have fuel going through the fuel pump and it does pump fuel to the carb. the bowl to the carb does get fuel, but the engine does not do anything. It doesn't try to start, or make any kind of attempt to start. Any ideas where to start to solve the problem? please and thank you
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Does spark jump a gap of 5/16" on this motor, yes or no.----Sparkplugs laying on the block is not a valid test.
 

parksy100

Recruit
Thread starter
Joined
Apr 11, 2017
Messages
2
used a spark plug tester, bulb would light up when I pulled the cord. the light was on the dim side but I wasn't sure if that was from it being an automotive spark plug tester or if it was because I have to use a pull cord on the boat engine.
​I will mess with it more this weekend when I don't have to work. is it possible that the fuel isn't going into the combustion chamber from the carb?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The magneto was designed and built to produce up to 28,000 volts.---------Therefor you should test the system for it's maximum output.--------It does not take 28,000 volts to jump the 0.030" gap on a sparkplug laying on the block.--------The plug in the cylinder with 80 lbs compression is a different story----------Do yourself a favour and try and make the spark jump a gap of 5/16" and listen for the " snap,snap " of a good magneto.------If the motor has sat for many years the coils may be cracked and need 2 new ones.--------I have many of these motors and all have new coils now.------Take the flywheel off.-----You will see 2 newer coils or it needs a set.
 
Top