1969 evinrude 115 no spark

Bradjcar91

Recruit
Thread starter
Joined
Jul 5, 2017
Messages
4
I recently bought a 1969 evinrude 115 motor that was none running. The problem was troubleshot back to the powerpack. I have since installed a new power pack but am still not getting spark. I mostly feel this is a problem with the way i wired the pack. Has anyone ever install the 113-8362 power pack? I feel the its not getting power to send to the coil. I guess what im asking is does my purple wire on terminal strip and after i run the blue wire to my coil do i need to run another wire from it to my strip?
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
No Title

Do you have voltage on the pulse pack's purple wire while cranking? Could be the ignition safety circuit. (If it still has one)

EDIT: Or could be an alternator problem. The alternator's output turns the safety circuit on while cranking or running.
 

Attachments

  • photo269595.jpg
    photo269595.jpg
    257.7 KB · Views: 5

Bradjcar91

Recruit
Thread starter
Joined
Jul 5, 2017
Messages
4
I have removed the safety circuit due to the warrenty saying it could be void if used with the new power pack. Since making this post i have borrowed a multimeter and when cranking the purple wire is only getting 6 volts. Samething goes for starter.
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Do some cranking tests with a volt meter and start at the battery.
 

Bradjcar91

Recruit
Thread starter
Joined
Jul 5, 2017
Messages
4
If i jump the battery i get 9. The instruction that came with the new power pack says it must be at least 10
 

JRegier

Petty Officer 2nd Class
Joined
Aug 17, 2013
Messages
136
Ah what a fun motor. I've got the same one on the back of my boat and I don't trust it further than I can throw it. I've got a factory service manual floating around somewhere I could look for to get you the numbers you should be seeing from the trigger under the flywheel. I know it sounds really obvious but are you testing for spark before or after the distributor? If you're checking it at the spark plug boots, take a look and make sure the flywheel key is intact and make sure the nub on the bottom of the plastic rotor under the distributor is intact.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
You may already have it figured out by now, but 6 to 9 volts is just crazy wrong. What post #5 says, start at the battery and go from there.
 
Top