1969 Aristocraft Tilt and trim problems.

landonsdad

Recruit
Thread starter
Joined
Aug 19, 2009
Messages
1
I have recently acquired a 1969 Aristocraft 19 with a 120 motor. I finally got it to run and it runs good after a total cleaning of the fuel pump and fixing a check valve that had a pin hole in it, but the tilt and trim are not working. To begin with the motor was not even trying to run. I took the motor all the way apart and cleaned everything in it and freed up the brushes. I put the motor back together and attached it to the pump tank. I hooked it up to a 12vdc source and the motor ran in forward and reverse. I also took the pump apart and all the balls and springs came out of the valve body. I finally got it put back together and freed up the pump gears and cleaned them. After i got it all put back together I filled it with oil and tried to run it. All it will do is click and i hear the motor trying to run but it wont turn either way and it will start getting very hot. I took it back apart again to assure myself that I got it back together correctly and it worked fine until I put it back in the pump with oil in it. Is there a chance that I have put the little check balls in the pump back in wrong and it is hyrolocking? Does anyone have a diagram of where the balls go if so? I put it back together the only logical way I could see and there does not seem to be any other way for them to go. Please help this is all that is holding me back.
 

foodfisher

Captain
Joined
Feb 18, 2009
Messages
3,756
Re: 1969 Aristocraft Tilt and trim problems.

Talk to RRitt. He hangs out in the force/chrysler forum.
 
Top