1969 6hp fisherman no power!

jonsilva

Cadet
Thread starter
Joined
Jul 12, 2016
Messages
18
I have a 1969 6 hp fisherman, when i got it, it ran rough and struggled to push me and my 11' flat bottom boat through the water. after figuring out i had no spark in one of the cylinders i replace both coils and condensers and both plugs. after doing this it ran much smother but still did not push the boat very well through the water, would not even plane on the water. I did a compression test on it yesterday and got 60lbs on the bottom cylinder and 56 lbs on the top cylinder. my question is. is that compression good for this motor? what else could be the problem?
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,421
that compression would be a bit low.

6hp wont plane your boat. 10hp may a 6hp is a kicker
 

jonsilva

Cadet
Thread starter
Joined
Jul 12, 2016
Messages
18
roughly how fat should it go with one person? should i replace the headgasket to get better compression ?
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,421
your motor is worn out, hence the low compression. you could re-ring it

it should probably move at 4mph which is hull speed for an 11' boat. to get out of the hole and up on plane, you will need more power
 

jonsilva

Cadet
Thread starter
Joined
Jul 12, 2016
Messages
18
is it worth it to put new rings on the pistons or should i be looking for a newer motor?
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Where would you find new rings ??------Best to look for a newer motor if planing is a must requirement.----The motor that replaced the 6 hp in 1980 is a 7.5 and that would be a better choice.----Those 1969 model 6 hp and like all of them from 1965 to 1979 are just excellent motors and hard to beat !
 

RCO

Petty Officer 1st Class
Joined
Jun 15, 2016
Messages
350
I would check the compression with another gauge for comparison before ripping into the motor. I would expect to see between 70-85 lbs on a perfect example. I would say on an 11' boat planing is a maybe/maybe not proposition depending on weight and hull design with that motor. It is a lot harder to plane out a narrow 11' boat than a wider 14' given the same weight.
 
Top