1967 johnson 40 hp wont start from key switch.

Zappella

Cadet
Thread starter
Joined
Apr 24, 2012
Messages
7
I think i have tried just about everything. Last year the engine ran great but every once in a while i would turn the key and nothing would happen. No clicking, turning over, nothing just dead. I would let it sit a minute then try again and most of the time it would start. Stowed it away for the winter in my basement and now this spring i tried putting it all back together. Went to turn the key and nothing. I did a few test using a multimeter, following the directions in the seloc manual and thought i narrowed it down to the starter solenoid. Bought a new one, installed it, turned the key and nothing. Could it possibly be the key switch or a bad wire going to or from the key switch to the motor? Any help would be great.
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Re: 1967 johnson 40 hp wont start from key switch.

Sounds like a ground problem. The solenoid needs to be grounded back to the engine to fire. I believe it grounds through the cut-out switch, so either the wiring is bad or the switch is bad.
 

Zappella

Cadet
Thread starter
Joined
Apr 24, 2012
Messages
7
Re: 1967 johnson 40 hp wont start from key switch.

So when you say either the switch is bad or the wiring, are you referring to the cut out switch or the starter solenoid?
 

Zappella

Cadet
Thread starter
Joined
Apr 24, 2012
Messages
7
Re: 1967 johnson 40 hp wont start from key switch.

Also, i went and had the skey switch tested and all seemed well. So i can cut that out of the equation. I got a new starter solenoid so i can eliminate that as well. So we have pretty much narrowed it down to wiring, or possible the cut out switch. Do you know how to testnthe cut out switch for operation?
 

Will Bark

Lieutenant
Joined
Aug 1, 2010
Messages
1,470
Re: 1967 johnson 40 hp wont start from key switch.

IMHO you need to clean "every connection" on solenoid, battery,and starter both negative and positive connection before you start running tests.
 

Zappella

Cadet
Thread starter
Joined
Apr 24, 2012
Messages
7
Re: 1967 johnson 40 hp wont start from key switch.

Aha! I appreciate the help. I have solved the problem. There is a safety switch under the edge of the flywheel on the starboard side of the powerhead. There was no ground wire attached at all. I built a wire and hooked it up and the motor fired right up. If there were any takeaways from this project it was that i have educated myself on wiring and electronics on these old motors. Thanks for the help. Much appreciated.
 
Last edited:

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Re: 1967 johnson 40 hp wont start from key switch.

Glad you got her running!
 
Top