1967 Johnson 40 Big Twin Throttle Bushing Removal

The Cod Father

Recruit
Thread starter
Joined
Jun 19, 2017
Messages
3
Brand new to the forum here, but it has already been helpful as I just got a boat. Picked up a 1967 Sea Lark 14' with a 1967 Johnson 40 Big Twin. The engine was fogged and put away 20 years ago. I have already confirmed compression, cleaned fuel lines, plugs, Carb rebuild Thursday, etc.... Engine turns over well with the pull start, but starter was shot. Havent full tried to start it till carb is done, there was some nasty old fuel in on line. Starter arrives arrives on Friday so hoping to get my last issue fixed soon. This brings me to my question. The throttle gear where the cable connects inside the upper unit is sheared so it doesn't grab the plastic pin of the rod. I need to replace the rod (corroded and wont turn by hand) and the throttle gear. I was hoping someone had some insight on popping the gear out without grinding off the bottom of the bushing. This is the one part I haven't been able to either figure out removal or find a topic on. Any help is appreciated!
 

The Cod Father

Recruit
Thread starter
Joined
Jun 19, 2017
Messages
3
Part #8 is what broke. The upright section snapped in half. But to remove it, there is a bushing that holds its underneath. Part #9.
 

RCO

Petty Officer 1st Class
Joined
Jun 15, 2016
Messages
350
Remove shaft (42 on diagram), and armature control rod, and the gear will just pull out.
 

The Cod Father

Recruit
Thread starter
Joined
Jun 19, 2017
Messages
3
Thank you guys so much for the quick and detailed responses. I'll be doing this Thursday with the carb!
 
Top