1966 johnston 40 outboard crab

redneck1574

Cadet
Thread starter
Joined
Jun 10, 2018
Messages
8
i clean carb and put back in and run idle 8 sec then spit pour gas out front carb i not sure if need vent control added or how fix this help me this is my first outboard engine let me know i needed help thanks
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Float valve is not closing properly.-----Replace the float needle and seat.
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
When you put it back together, did you install the float upside down?
 

redneck1574

Cadet
Thread starter
Joined
Jun 10, 2018
Messages
8
float is a cork i could not find other one like brass or plastic that year come with cork so not sure maybe that why or needle bad? i look needle look good
 

RCO

Petty Officer 1st Class
Joined
Jun 15, 2016
Messages
350
Did you check the float to see if it still floats? If it is the original shellac coated float, throw it out and replace it. The ethanol in the fuel will eat the shellac and give you fits. It is definitely worthwhile to replace the needle and seat, the replacement needle should have a viton tip with a clip that goes onto the float arm.
 
Top